Applying Wall Graphics

Requirements for installation:

It will take a minimum of 2 people to properly install your wall decal.  Be sure to clean the wall surface before the installation.

You will need the following items in order to properly install your window graphic:

  • Soap & water to clean the wall
  • A soft, clean lint-free cotton cloth
  • A new, sharp razor for trimming to size
  • Masking tape
  • Measuring Tape

Preparing the Surface: The wall must be thoroughly cleaned before the decal is applied. Clean the wall using soapy water, and then thoroughly rinse and dry the wall. Be sure that the wall is completely free from any remaining soap residue.

Before removing backing material, unroll the graphic and select the position on the wall that is desired. You may wish to use masking tape along the top edge to temporarily hold the graphic in the desired position. Be sure to measure accurately for exact placement on your desired surface.

Once desired placement is selected, position 1 person on either side of the wall and carefully begin removing the backing material starting from the top and working your way to the bottom while adhering to the wall.

WARNING: DO NOT STRETCH THE MATERIAL. THIS WILL CAUSE THE PRODUCT TO CURL AND LIFT FROM THE WALL AFTER IT IS INSTALLED. While pealing away backing material, gently smooth the film against the wall.

If air bubbles form during this process, gently lift the material and reapply while smoothing the bubble area. Once graphic is completely flat against the wall and all wrinkles and air bubbles are removed, start from the center of the wall and gently rub the entire area with a soft, clean, lint-free towel to secure the adhesive to the wall.

Carefully trim with the razor blade the excess material around the perimeter of the wall trim.

WARNING: USE EXTREME CAUTION WHEN TRIMMING TO AVOID INJURY AND TO AVOID DAMAGE TO YOU, THE WALL, OR GRAPHIC. Discard excess material.

Removal Instructions:

The product can be easily removed by starting at one corner and gently pealing the film from the wall. If necessary, use a plastic scrapper to help loosen the material from the wall, then peal away from the wall. Remaining residue can be easily removed with soap and water.

WARNING: Use extreme caution when using any sharp objects as they can cause severe injury.

 

Print these Instructions

Big Dog Bottom